Author Guidelines
 
It is necessary for the authors to write and prepare their manuscripts according to the instructions and specifications listed below. The length and effectiveness of the peer review process will largely depend upon the care used by authors in preparing their manuscripts. Therefore, contributors are strongly encouraged to read these instructions carefully before preparing a manuscript for submission and to check the manuscript for conformance before submitting it for publication.
 
Manuscripts which are submitted should
  1. Contain original work (submit a covering letter stating that the article has not been communicated to any other journal for publication).
  2. Follows aims and scope of the journal
  3. Clearly and correctly written in English
  4. Are delivered in electronic format
Paper elements
  1. Title page with:
    1. Title (short title)
    2. Name(s) of author(s)
    3. Name and address of workplace(s)
    4. Personal e-mail address(es)
  2. Abstract
  3. Keywords
  4. Text
  5. References
Each of these elements is detailed below:

1.1 Title (short title)

Title should be short but informative.

1.2 Name(s) of author(s)

A list of all authors of the paper should be prepared (full first name, initial(s) for middle name(s) and full last name).

1.3 Name and address of workplace(s)

Authors' affiliations should be indicated in this section.

1.4 Personal e-mail address (es)

At least one e-mail address is needed for corresponding with the authors.

2.Abstract

An abstract must accompany every article. It should be a brief summary of the significant items of the main paper. An abstract should not normally exceed 200 words. It should not contain literature citations or allusions to the tables or illustrations.

3. Keywords

List of all keywords proposed by the authors, separated by commas.

4. Text

  1. Introduction: subject, scope of the subject, goals of your paper and finally the organization of your paper are to be mentioned
  2. Main text: all important elements of your scientific message are to be mentioned
  3. Conclusion: summary of the paper

Experimental Part
Should be written in sufficient details to enable others to repeat the authors' work.

Results and Discussion
May be combined or kept separate and may be further divided into subsections. This section should not contain technical details. Abbreviations and acronyms should be used sparingly and consistently.

Acknowledgements
Information concerning research grant support and the assistance of colleagues or similar notes of appreciation should appear in an Acknowledgements section.

Tables
Authors should use tables only to achieve concise presentation, or where the information cannot be given satisfactorily in other ways. Tables should be numbered and referred to in the text by number. Each table should have an explanatory caption which should be as concise as possible.

Figures
 Authors may use line diagrams and photographs to illustrate these from their text. The figures should be clear, easy to read and of good quality. Styles and fonts should match those in the main body of the article. Lettering and lines should be of uniform density and the lines unbroken. All figures must be mentioned in the text in consecutive order and be numbered.

Images
 Authors can attach files in formats like BMP, GIF, JPEG formats.

5. Reference list
 A complete reference should give the reader enough information to find the relevant article. Please pay particular attention to spelling, capitalization and punctuation here. Completeness of references is the responsibility of the authors. A complete reference should comprise the following:

5.1. Reference to an article in a journal

Books:

[1]
 G. O. Young, “Synthetic structure of industrial plastics,” in Plastics, 2nd ed., vol. 3, J. Peters, Ed. New York:McGraw-Hill, 1964, pp. 15–64.
[2]
 W.K. Chen, Linear Networks and Systems. Belmont,CA: Wadsworth, 1993, pp. 123–135.

Periodicals:

[3]
J. U. Duncombe, “Infrared navigation-Part I: An assessment of feasibility,” IEEE Trans. Electron Devices, vol.ED-11, pp. 34–39, Jan. 1959.
[4]
E. P. Wigner, “Theory of traveling-wave optical laser,” Phys. Rev., vol. 134, pp. A635–A646, Dec. 1965.
[5]
E. H. Miller, “A note on reflector arrays,” IEEE Trans.Antennas Propagat., to be published.

Articles from Conference Proceedings (published):

[6]
D. B. Payne and J. R. Stern, “Wavelength-switched passively coupled single-mode optical network,” in Proc .IOOC-ECOC, 1985, pp. 585–590.

Papers Presented at Conferences (unpublished):

[7]
D. Ebehard and E. Voges, “Digital single sideband detection for interferometric sensors,” presented at the 2nd Int. Conf. Optical Fiber Sensors, Stuttgart, Germany, 1984.

Standards/Patents:

[8]
G. Brandli and M. Dick, “Alternating current fed power supply,” U.S. Patent 4 084 217, Nov. 4, 1978.

Technical Reports:

[9]
E. E. Reber, R. L. Mitchell, and C. J. Carter, “Oxygenabsorption in the Earth’s atmosphere,” Aerospace Corp.,Los Angeles, CA, Tech. Rep. TR-0200 (4230-46)-3, Nov.1968.
 
Font type
Articles should be typed in single line spacing with the following font pattern
 
Font type
Size : For heading or title
Author/ Coauthors name
Affiliation/ Institute name
Content of article
Table title and Content
 : Times new roman
: 14 points and Bold (Title Case)
: 11 points and Bold
: 11 points
: 11 points
: 10 points
 
If you have any questions, please contact at gonivjournals@gmail.com